Products → ARC Industrial Coatings → Abrasion Resistant Composites for Metal → ARC MX FG

ARC MX FG

Chesterton ARC MX FG is a 100% solids, zero-VOC, ceramic-reinforced epoxy coating designed to protect metal surfaces from fine particle abrasion in both dry and wet slurry conditions. It is trowel-applied and cures to a hard, durable finish, offering a longer-lasting alternative to rubber linings and ceramic tiles.

This coating is suitable for equipment exposed to fine particle wear, including cyclones, valves, hopper bins, transport screws, wear plates, slurry pumps, agitators, mixers, cleaner cones, pipe spools, pipe elbows, and pulverizers. It complies with 21 CFR 175.300 for direct food contact applications, making it suitable for use in the food processing industry.

Not Sure What You’re Looking For? Contact Us

Paint kit with cans, a paintbrush, and instructions on a table.

Product Features

✔ Tough, ceramic-reinforced coating that resists broad range of slurries
✔ Protects metal surfaces from extreme sliding-wear and abrasion caused by fine particles
✔ Restores worn equipment to near original condition
✔ Provides a longer lasting alternative to rubber linings and ceramic wear tiles
✔ Extends life of equipment exposed to fine particle wear 
✔ Resists a broad pH spectrum
✔ Applies easily by trowel

Technical Data ↓

    • Cyclones

    • Valves

    • Hopper bins

    • Transport screws

    • Wear plates

    • Slurry pumps 

    • Agitators

    • Mixers

    • Cleaner cones

    • Pipe spools

    • Pipe elbows

    • Pulverizers

  • Complies with 21 CFR 175.300 for direct food contact as follows:

    • Type II – Acidic (pH 5.0 or below), aqueous products; may contain salt or sugar or both, including oil-in-water emulsions of low or high fat content food.  

    • Type III – Aqueous, acid or non-acid products containing free oil or fat; may contain salt, and including water-in-oil emulsions of low or high fat content.

    • Type IVA – Dairy products and modifications: Water in oil emulsion, high or low fat.

    • Type IVB – Dairy products and modifications: Oil in water emulsion, high or low fat.

    • Type V – Low moisture fats and oils. Condition C.

    • Type VIII – Dry solid foods.

  • 266 °F ( 130 °C )

  • 149 °F ( 65 °C )

  • 22.1 Mpa ( )

  • White

  • Nominal, based on a 3 mm (120 mils) thickness

    • 1.5 liter kit covers 0.5 m2 (5.4 ft2)​

    • 5 liter kit covers 1.67 m2 (18 ft2)​

    ​Note: Components are pre-measured and pre-weighed. Each kit includes mixing and application instructions plus tools.

Not Sure What You’re Looking For? Contact Us